These beeps occur only once when you are attempting to activate the unit via your remote control.

If after pressing your remote control you get a series 5 beeps, pause, 5 beeps, pause without pressing the remote, please refer to THIS page.

Step 1:

• Make sure all your lock wires are secure.
• Turn the system off.
• Remove the red, black, and blue wires from the control board.
• Inspect and replace the wires back into the terminals.
• Turn the system on and test with your remote control.
• If the issue persists, proceed to step 3.

Step 2:

• Check for binding at the closed position between the receiver lock pin and lock.
• If the pin is resting against the lock draw bolt you will need to readjust your gate closed position.
• Please refer to your installation manual (available here) for the automatic gate opener and the Zombie Lock Manual.

How do I reset the Ghost Controls System when a ZombieLock is missing or removed?

Example Scenarios:

1. I previously had a Ghost Controls AXZL ZombieLock installed and now I have removed it for some reason or another. How do I get my Ghost Controls system to work again now that I have removed the AXZL ZombieLock from the installation?
2. I currently have a Ghost Controls AXZL ZombieLock on my gate but I have disconnected the wires from the control board. I want to manually keep the ZombieLock open using the key.

Follow this procedure:

• If your system is not off already, turn the system control board OFF using the switch on the outside bottom of the system control box.
• Hold down BOTH the “JOG OPEN” and “JOG CLOSE” buttons for the 1st Arm.

• Turn the system control board ON and continue to hold the JOG OPEN and JOG CLOSE buttons down for approximately 6-8 seconds.
• Your system has now reset.
• Test your system operation with the Remote Transmitter.